Brewtools EVA Hose 8.5×14mm - Reinforced Water & Glycol Cooling

Brewtools EVA hose is the official cooling line for the Brewtools ecosystem — a reinforced 8.5mm ID × 14mm OD hose purpose-made for the cooling water and glycol runs that connect a Brewtools brewing system or fermenter to its cooling supply. Sold per meter, it's the hose that completes the cooling setup on the new-generation B25, B50, B100, and B180 systems: one run for the cooling jacket inlet, one for the outlet, connected through the Brewtools Cooling Connector Kit.

What makes EVA the right material for cooling lines is its behaviour under bends and temperature. Cooling runs rarely travel in straight lines — they route around the system, down to a drain, or across to a glycol chiller — and a standard soft hose kinks and collapses at exactly those bends, choking the flow the cooling jacket depends on. Brewtools' reinforced EVA construction holds its bore through tight routing, keeping flow rates up and cooling performance consistent from the first litre to the last. It handles both cold tap water and chilled glycol, making it equally at home on a brew-day chilling run and a permanent glycol loop to a fermentation setup.

Sized to match the Brewtools quick connectors and Cooling Connector Kit, this is the correctly specified hose for the ecosystem — order the combined length you need for both the inlet and outlet runs, with a little spare for clean routing.

⸻

Key Features

• Official Brewtools cooling hose — 8.5mm inner × 14mm outer diameter
• Reinforced EVA construction — holds its bore through bends without kinking or collapsing
• Suitable for cooling water and glycol lines
• Matched to Brewtools quick connectors and the Cooling Connector Kit
• Sold per meter — order exactly the length your routing needs
• For brewing system cooling jackets and glycol runs to fermenters

⸻

Usage

Best suited for: Cooling jacket inlet and outlet runs on Brewtools B25, B50, B100, and B180 systems, glycol lines to Brewtools fermenters, general water and glycol plumbing in the Brewtools ecosystem

Compatible with: Brewtools Cooling Connector Kit, Brewtools quick connectors, tap water and glycol cooling supplies

Note: Order sufficient length for both the inlet and the outlet run — a cooling jacket needs two lines. Sold per linear meter.

⸻

Quick facts

Brand: Brewtools
Type: Reinforced EVA cooling hose
Inner diameter: 8.5mm
Outer diameter: 14mm
Media: Cooling water and glycol
Sold: Per linear meter
Pairs with: Brewtools Cooling Connector Kit and quick connectors
Use: Cooling jacket lines, glycol runs, Brewtools cooling setups

Pre-order note:

Brewtools’ new 2026 generation accessories. Reserve yours now through CraftBrew as an official Brewtools dealer to secure your place in the first delivery — shipping expected from late September.